EV charger installation in Nanaimo
Home charging done right the first time — the right circuit, the right charger location, and a panel check before anything is promised. We install Level 2 home chargers on a dedicated circuit, sized to the charger and your panel.
No charger is promised until the panel checks out. Before quoting, we check the panel and do a load calculation where needed, so you are never promised a charger your service cannot support.
What's included
- Panel check and load calculation — before quoting, we confirm what your service can carry.
- Charger location and cable run — the shortest sensible run to where you actually park, indoors or out.
- Dedicated circuit — sized to the charger and your panel, wired to code, hardwired or plug-in.
- Permit and inspection — we handle the Technical Safety BC permit and the inspection as part of the job.
- An honest answer if the panel is full — we tell you what an upgrade would take before you commit to anything.
We also wire dedicated circuits for hot tubs, heat pumps, garages, and shops — often on the same visit, if the panel allows.
Will my panel handle it?
That's the first question, and it's answered with numbers, not guesses. A load calculation weighs everything already on the service against what the charger adds. Many 100-amp services carry a Level 2 charger fine; some don't — and the answer depends on your heating, range, dryer, and water heater, not on how many spare breaker spaces you see.
If the numbers are close, two things can still save an upgrade: your BC Hydro meter data can show room the standard calculation doesn't, and a load-management device can let a charger run safely on a service that couldn't otherwise carry it. Ask us before assuming you need a bigger service.
Run the free load calculator to check your own service, or send us a photo of your panel and we'll check it.
Level 1 vs Level 2 — what's the difference?
| Level 1 | Level 2 | |
|---|---|---|
| Power | 120 V, regular outlet | 240 V, dedicated circuit |
| Charging speed | A few km of range per hour | Roughly 40–60 km of range per hour, depending on the charger and the vehicle |
| Install | None — plug into any outlet | New circuit, permit, and inspection |
| Best for | Very short daily driving, plug-in hybrids | Daily EV driving, full overnight charging |
Most EV owners end up at Level 2 — it's the difference between charging overnight and charging over a weekend.
How the job goes
- Tell us the job. Call, use the quote form, or email — with a photo of your panel and where you'd like the charger, if you can.
- Panel check and written quote. We check the panel, run the load calculation where needed, and quote the job — including the permit — before anything starts.
- Permit and install. We pull the permit, run the circuit, mount and wire the charger. A straightforward install is usually done in a day; longer cable runs and panel work take longer.
- Inspection. The work is inspected, and you're charging.
Permits
An EV charger needs an electrical permit and an inspection — it's a new dedicated circuit. We handle both as part of the job. Not sure about a different job? Check it with the permit checker.
Rebates
BC's CleanBC Go Electric program currently offers up to 50% of eligible costs, to a maximum of $350, for a Level 2 charger at a single-family home (program guide dated April 1, 2026) — one rebate per address, claimed within 6 months of the charger invoice. Higher amounts apply for multi-unit buildings and Indigenous applicants. Rebate amounts and rules change, so confirm the current program before the job at goelectricbc.gov.bc.ca. We'll tell you what paperwork the claim needs.
Strata or condo?
Charging in a strata or condo usually needs the strata involved — approval, and a check of the building's shared capacity — before any work starts. The process is different from a detached home, and it starts with the strata, not the charger. Tell us the building and we'll advise on the first step.
Service area
We're based in Nanaimo, at 6257 Shoreline Drive, with regular work in Nanaimo, Lantzville, Nanoose Bay, Parksville, Qualicum Beach, Cedar, Ladysmith, and Gabriola Island.
Licensed & insured. Harbour Electrical Services Ltd. — Technical Safety BC licence LEL0102076. Work done by a Class B Field Safety Representative.
Ready to charge at home?
Tell us the charger — or the car — and send a photo of your panel. We'll check the service and quote the job, including the permit, before you commit to anything.